-
Find the remote codes for the devices you want to set up. You can find the latest codes below:
Codes
Televisions
DVDs
VCRs
Audio Receivers
Audio Amplifiers
In addition, remote codes are listed in the Philips RC144 Remote Control User Guide. -
Write down the remote codes for the devices you want to set up.
-
Turn on the device you want to program into your remote, for example if you are programming your remote to control your TV, then turn on the TV.
-
Press and hold the appropriate device button and press OK.
-
Release both buttons. The device buttons blink twice.
- Enter the remote code for the device (if there is more than one remote code listed for your equipment, start with the first remote code in the list).
- Point the remote at the device and press the Power button.
- Repeat this procedure for each device you want to program into your remote control.
The device button blinks three times.
Did the device turn off?
Yes: Keep the code you wrote down above for future reference. You may need it again if the remote code is accidentally erased.
No: Repeat these steps using the next remote code listed for your equipment.
Note: If none of the listed codes work for your equipment, you can use your remote to .