Note: These steps only apply to the Motorola DRC800 Remote Control. If this is not the make and model of your remote, go to the supported remote control models page and find the instructions for your specific remote control.
Searching for a Device Code
- Turn on the device you want to program into your remote, for example if you are programming your remote to control your TV, then turn on the TV.
- Press and hold for six seconds the device button for the device you turned on in step 1 (AUDIO, DVD/VCR, TV, CABLE).
- Press the Power button on your remote.
- Press the Up arrow button (this is the button directly above the OK button, not the Page Up button).
Note: The DVD/VCR button can control a DVD, VCR, or a combination TV/DVD, TV/VCR, or TV/DVD/VCR.
The lights for each device button light up and the light for the device button you selected remains on.
The device button blinks three times then turns off.
Did the device turn off?
Yes: Congratulations! You've found the correct code for that device. Press OK to store the code in your remote control.
No: Repeat step 3 and 4 until your device turns off, then press OK to store the code in the remote control.
Note: To retry the previous code, press the Down arrow button (not the Page Down Arrow button).